Laser Sensing

Laser sensing works in a similar method to touch sensing. However rather than having a physical wire that requires a circuit to form to detect contact, a laser is used where that same “contact” is detected when the distance measured by the laser is within a certain range.

Laser sensing has a number of advantages over touch sensing:

  • There is no wire to cut, avoiding the time taken to move and cut the wire.

  • The laser cannot be bent or damaged like a welding wire.

  • There is no problem with the wire moving between wire cutting and sensing.

  • It can be used to sense non-conductive surfaces such as plastic or painted parts and fixtures.

The main disadvantage is that there is another item to path find that can add a small amount of error to the overall path finding system, and it is not suitable for some reflective surfaces.

Verbotics Weld expects the laser to work as follows:

  1. If the laser is out of range, the input should be low.

  2. If the laser is above the threshold distance the input should be low.

  3. If the laser is in range and below the threshold distance, the input is high.

Effectively the laser has a similar function as a virtual welding wire in this range.

../../_images/laser-sensing-1.png

Laser sensing thresholds

This allows for the laser to be used as a wire tip, where the laser search is moved from above the threshold, to the threshold. Or in a side touch mode, where the laser is moved from out-of-range to within range and below the threshold.

../../_images/laser-sensing-2.png

Laser sensing touch types

To set your workcell up for laser sensing we need the following information along with a 3D model detailing how your laser is mounted to the robot. The Laser TCP is the furthest point where the output is expected to be high. The sensing range is the distance bewteen the Laser TCP and where the output will be expected to be low due to being inside the minimum sensing distance of the sensor.

Parameter

Recorded Value (Laser TCP)

Laser TCP X (mm)

Laser TCP Y (mm)

Laser TCP Z (mm)

Sensing Range (mm)

For best results the sensing range should be at leat 50mm. The laser TCP should also be positioned such that it will not be obstructed by the welding nozzle.